Checking The Program - Omron SYSMAC CPM2B Operation Manual

Programming Console Operations
Corrected Program
00100 00101
00201 00102

7-2-13 Checking the Program

1,2,3...
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
If the instruction has more operands, the operands will be deleted automat-
ically with the instruction.
After completing the insertion and deletion procedures, use the Up and Down
Arrow Keys to scroll through the program and verify that it has been changed
correctly, as shown in the following diagram.
00104
00105
01000
END(01)
This operation checks for programming errors and displays the program
address and error when errors are found. It is possible in PROGRAM mode
only.
RUN
No No
1. Press the CLR Key to bring up the initial display.
2. Press the SRCH Key. An input prompt will appear requesting the desired
check level.
3. Input the desired check level (0, 1, or 2). The program check will begin
when the check level is input, and the first error found will be displayed.
4. Press the SRCH Key to continue the search. The next error will be dis-
played. Continue pressing the SRCH Key to continue the search.
The search will continue until an END instruction or the end of Program
Memory is reached. A display like this will appear if the end of Program
Memory is reached:
A display like this will appear if an END instruction is reached:
00205 DELETE END
↑
AND
Address Instruction
00205 AND
00206 AND NOT
00207 OUT
00208 END(01)
MONITOR PROGRAM
OK
00000PROG CHK
SRCH
CHK LBL
00178CIRCUIT ERR
A
0
OUT
00300NO END INST
SRCH
END
00310PROG CHK
SRCH
END (001)00.3KW
No more errors exist if the END
instruction is displayed.
Section 7-2
00105
Operands
00105
00104
01000
-
(0-2)?
00200
139