Table of Contents
Advertisement
AS-i CC-Link Gateway
Installation
6.2
Installing in the control cabinet
The AS-i CC-Link Gateway is installed in the control cabinet on 35mm DIN rails
per DIN EN 50 022.
Information!
The enclosure of the AS-i/Gateway is made of stainless steel. The unit is also suitable
for exposed wall mounting.
Warning!
Cover the top of the gateway when doing any drilling work above the unit. No particles,
especially metal chips, should be allowed to enter the housing, since this could cause a
short circuit.
To install, place the unit on the upper edge of the DIN rail and then snap in the
lower edge.
-
+
+
6.3
Removing
+
-
+
To remove, press the holding clamps [2] down using a screwdriver [1], press the
unit firmly against the upper rail guide and lift out.
12
-
-
+
-
+
-
[1]
3
2
[2]
1
Advertisement
Table of Contents
