Network; Basic - TRENDnet TEW-841APBO User Manual

TRENDnet User's Guide

Network

Basic

Network > Basic
This page allows configuration of the access point's IPv4, IPv6, and Spanning Tree
Protocol settings.
1. Log into your access point management page (see
management page" on page 27).
2. Click on Basic under Network from the left side menu. Please note, when clicking
Save, the settings are saved but not applied yet.
IPv4 Settings

IP Network Setting – Select either DHCP or Static IP. Default: DHCP

IP Address – Enter the desired IPv4 address if above setting is set to static IP.

Subnet Mask – Enter the desired IPv4 subnet mask.

Gateway – Enter the desired IPv4 Gateway.

Primary DNS – Enter the desired primary Domain Name Server (DNS).

Secondary DNS – Enter the desired secondary Domain Name Server (DNS).
© Copyright 2019 TRENDnet. All Rights Reserved.
"Access your access point
IPv6 Settings

Link-local Address – Check the box to enable IPv6 Link-local Address setting.

IP Address – Enter the desired IPv6 address.

Subnet Prefix Length – Enter the desired IPv6 subnet prefix length.

Gateway – Enter the desired IPv6 Gateway.

Primary DNS – Enter the desired primary Domain Name Server (DNS).

Secondary DNS – Enter the desired secondary Domain Name Server (DNS).
Spanning Tree Protocol (STP) Settings

Status – Select either to Enable or Disable STP. Default: Disabled

Hello Time – Enter the desired hello time (in seconds)

Max Age – Enter the desired max age (in seconds).

Forward Delay – Enter the desired forward delay (in seconds).

Priority – Enter the desired priority of this STP configuration.
TEW-841APBO
30