TRENDnet TEW-841APBO User Manual page 39

TRENDnet User's Guide
RSSI Threshold

Status – Select Enable to enable the RSSI threshold feature.

RSSI – Enter the RSSI threshold to trigger the AP to encourage the client to
switch to another AP with a stronger signal. The more negative the number,
the weaker the signal strength. A "-100dBm" is essentially an empty signal
strength.
Management VLAN Settings: When enabled with a specified VLAN ID, the device will
only allow management interface access with the specified VLAN ID.

Status – Select Enable to enable this feature then enter in the VLAN ID. .
3. Click Save at the bottom of the page to save your settings.
© Copyright 2019 TRENDnet. All Rights Reserved.
MAKE SURE THE CHANGES TO THE CONFIGURATIONS ARE
APPLIED

Click Changes
Apply .

Click Apply on the bottom right of any page:
TEW-841APBO
from the top right menu bar, and click
OR
36