3. To verify connectivity, in the TEW-740ABPO #2 web management interface, click on Utility
and click on Network Utility.
Network Utility
4. In the IP/Domain field, enter the IP address of TEW-740APBO #1, 192.168.10.50, then next
to Times, click Ping.
5. Ping replies and 0% packet loss will indicate as successful point to point bridge connection
between the TEW-740APBO #1 and #2.
Note: If the connectivity test fails, wait for about a minute and try again. Make sure there are no
obstacles between the two access points when running the connectivity test and make sure the
two access points are not too close together.
13
Utility