Backup And Restore Your Access Point Configuration Settings; Reboot Your Access Point - TRENDnet TPL-410AP User Manual

TRENDnet User's Guide

Backup and restore your access point configuration settings

Administration > Backup/Restore
You may have added many customized settings to your access point and in the case that
you need to reset your access point to default, all your customized settings would be
lost and would require you to manually reconfigure all of your access point settings
instead of simply restoring from a backed up access point configuration file.
To backup your access point configuration:
1. Log into your access point management page (see
management page" on page 9).
2. Click on Administration and click on Backup/Restore.
3. Next to Save Settings to Local Hard Drive section, click Save Configuration.
4. Depending on your web browser settings, you may be prompted to save a file (specify
the location) or the file may be downloaded automatically to the web browser
settings default download folder. (Default Filename: tpl410cfg(#).dat)
To restore your access point configuration:
1. Log into your access point management page (see
management page" on page 9).
2. Click on Administration and click on Backup/Restore.
3. Next to Load Settings From Local Hard Drive, depending on your web browser, click
on Browse or Choose File.
4. A separate file navigation window should open.
5. Select the access point configuration file to restore and click Restore. (Default
Filename: tpl410cfg(#).dat). If prompted, click Yes or OK. Wait for the access point to
restore settings.
© Copyright 2014 TRENDnet. All Rights Reserved.
"Access your access point
"Access your access point

Reboot your access point

Administration >Restart
You may want to restart your access point if you are encountering difficulties with your
access point and have attempted all other troubleshooting.
There are two methods that can be used to restart your access point.
• Turn the access point off for 10 seconds using the access point On/Off switch
located on the right side of your access point or unplugging the device from the
power source, see "Product Hardware
back on either using the On/Off switch or plugging the device back into the
power source.
Use this method if you are encountering difficulties with accessing your access
point management page. This is also known as a hard reboot or power cycle.
OR
• Access Point Management Page – This is also known as a soft reboot or restart.
1. Log into your access point management page (see
management page" on page 9).
2. Click on Administration and click on Restart.
3. Click Restart. Wait for the device to reboot.
TPL-410AP / TPL-410APK
Features" on page 2. Then turn the device
"Access your access point
25