Dog trace d-control 600 User Manual page 11

Switching the receiver ON / OFF
To turn the receiver ON / OFF ( or for programming the transmitter with the receiver) is used
a magnetic switch, marked with the red target on the receiver. The receiver is activated
when the magnet in bottom of the transmitter, is enclosed to the red target on the receiver.
Switching ON
Move the red target of the receiver towards the bottom of the transmitter for 1 second
(see the Fig.). The red LED indicator of the receiver will lit up, afterwards the green LED
indicator will start blinking. The receiver is prepared for use.
Switching OFF
When switching OFF, follow the same steps as when switching ON.
Move the red target of the receiver towards the bottom of the transmitter - the green LED
indicator of the receiver will lit up, afterwards the red LED indicator will lit up.
IMPORTANT: When turning the receiver ON hold
the red target of the receiver close to the red target
of the transmitter for about 1 second. When the
targets are close to each other for longer than
5 seconds the receiver will switch to the pairing
(programming) mode of the transmitter with the
receiver. This programming mode is indicated by
alternate flashing of the red and green LED indicator.
If this occurs, follow the chapter Programming
(pairing) the transmitter with the receiver.
Caution: To extend the battery life, it is necessary to turn
off the receiver and transmitter whenever the training of
your dog is finished. If you do not use the device for a
long time, we recommend you to remove the batteries
out.
The position where the receiver
is turned ON/OFF and where
the transmitter is being paired
with the receiver.
11