Please read this paragraph carefu lIy before start the calculation.
When the power switch is turned on all zeros are displayed in a moment after that
only zero of 1st digit stays on and others are turned
In this time the automatic clear function works to clear the unit
Therefore the calculation can be started
Before manual calculation is started program switch must be adjusted to the "N"
In the following
the switches of Tabulation. Rounding and Constant are
selected as follows;
(R) TAB ...... For the calculation register
For the memory register
... Selected position
... Rounding up
Rounding down (Discarding)
Selected "K" position
When there is no indication regarding constant switch. selected "N"
7 .... (M) TAB
Tabulation selector for the calculation register is selected
Rounding switch for the calculation register is selected "Rounding up" position.
the memory register is selected "2" position.
Rounding switch for the memory register is selected "Rounding off" position.
Constant switch is selected "K" position.