Sharp COMPET CS-363 Series Instruction Manual page 109

2. Card control key
I ENTER I
IRECORD/
I
VERIFY /
Before using the card control keys. be sure to set the program switch at any mode other
than "N " mode.
This is used to transfer the program from the card to the program memory inside the
computer. In this case. the problem on the card is not destroyed and the previous
program in the program memory is lost.
This is used to transfer the program stored in the computer by manual operation into the
card . But even when it is transferred to the card. the program recorded in the computer
will remain as it is. When
A
part or
B.
part of the card is cut out for permanent recording
of program. this operation is regarded aslVERIFylprocedure described below.
This is used to verify of both programs on the card and in the program memory of the
computer. When the two do not match completely. the overflow error lamp turns on .
When two keys of these card control keys are operated by mistake. the same instruction
aslVERIFylshall be given whichever two keys may have been operated.
Note: 1. I f the card control key is operated when program switch is at "N" position. the
overflow error lamp turns on .
2. When the card control key is operated during program calculations at " A " position.
such calculation is nu lified and operation stops. I n this case. the instruction of
.. Record ..... Verify .. or "Enter" is given according to the selected key operation .
104