4 Quick Setup
Overview
4.1
This chapter briefly describes the setup of the INVOS™ regional saturation patient monitoring
system (see also Chapter
plete instructions).
Initial Setup
4.2
Plug in the INVOS™ system monitor to a power source.
1.
Note:
The blue
LED illuminates to indicate the power is connected and the battery is charging. If the blue
light is not on, turn the back panel master (mains) power switch on.
Connect the preamplifier or preamplifiers to the monitor. Align the red dot on the preamplifier cable
2.
silver connector with the red dot on side panel input connection. Insert the cable connector into the
side panel connection while keeping the dots aligned. Be sure to fully insert the connector until it
locks.
Connect the reusable sensor cable connectors to the preamplifier or preamplifiers. Use the color
3.
coding.
1
Introduction, Chapter
3
Figure 4-1. Connecting the Preamplifier to the Monitor
Installation, and Chapter
6 Operation
for com-
4-1