Changing Channels; Volume And Squelch Adjustment; Ptt (Push To Talk); Selecting Transmission Power - Simrad WR20 RemoteCommander Manual

WR20 Remote Commander
Note
Press P
RODUCT

7.3 Changing channels

To select the required channel press the
or decrement the channel number.
7.4 Volume & squelch adjustment
To select the volume of the external loudspeaker, press the
The display now shows "VOL" highlighted in the display. Use
or to adjust the volume to the required level.
To select the squelch, press the
"SQL" highlighted in the display. Use
squelch setting.
Adjusting "VOL" or "SQL" is only available for 3 seconds - if
are not pressed within this time, their function reverts to channel select.
While the WR20 is in the radio mode, the "VOL" and "SQL" level
will be displayed as a bargraph on the left and right hand sides of
the display respectively.

7.5 PTT (Push to talk)

Pressing the PTT key on the side, will enable the Remote
Commander to transmit voice, via the internal microphone, on the
selected channel. "Tx" will be shown in the display, and you will
hear the reply on the internal speaker when the PTT is released.

7.6 Selecting transmission power

Press the 1W/25W SoftKey to toggle between 1W/25W transmitter
power.

7.7 Selecting emergency channel 16

To select Channel 16 press the CH16 SoftKey. Channel16 is now
the active channel and shown in the centre of the display.
Press the
44
at any time, to see the product list.
or to return to another channel .
key
or keys to increment
key. The display now shows the
or to adjust the
key.
or