Installation; General; Installing The Recharge Cradle; Charging The Wr20 Handset Battery - Simrad WR20 RemoteCommander Manual

2 INSTALLATION

2.1 General

There is no installation required for the Handset which is already
"paired" to the Basestation and ready to use. Installation of the
Basestation and recharge cradle is very simple.

2.2 Installing the recharge cradle

Choose a convenient, dry location to mount the Handset cradle
using the two screws provided. A 12V power cable is supplied and
this should be connected to a suitable supply fused at 2A. Connect
the Red wire to +12V and the Black wire to 0V (Ground).

2.3 Charging the WR20 Handset battery

Push the Handset firmly into the cradle, (Fig. 2.1) and the Handset
battery will charge. If the Handset is switched off the charge status
will be indicated in the display. The unit may be switched on and
will function normally while charging.

2.4 Installing the Basestation

Careful consideration must be given to the location of the
Basestation to ensure optimum performance.
Fig. 2.1 - WR20 Charging Cradle
Installation
13