Cabled Psu Back Panel Features - Dell E28S Series Owner's Manual

Table 6 Redundant PSU back panel features (continued)
Item
10
11
12
13
14

Cabled PSU back panel features

Figure 8 Cabled PSU back panel features
1. Serial connector
2. Ethernet connector 1
3. vFlash card slot (optional)
4. iDRAC port (optional)
5. PCIe expansion card slots (2)
6. Video connector
Indicator, Button, or Icon
Connector
System identification
button
System identification
port
Ethernet port 3
Ethernet port 4
Power supply unit
(PSU1 and PSU2)
Description
Press the system ID button:
To locate a particular system within a
l
rack.
To turn the system ID on or off.
l
Note: To reset the iDRAC (if not disabled
in F2 iDRAC setup), press and hold the
button for more than 15 seconds.
Note: If the system stops responding
during POST, press and hold the system ID
button (for more than five seconds) to
enter the BIOS progress mode.
Use the system identification port to connect
the system status indicator assembly through
the optional cable management arm.
Use the Ethernet port to connect Local Area
Networks (LANs) to the system. For more
information about the supported Ethernet
ports, see the Technical specifications section.
Up to two 550 W redundant AC power
supplies.
Dell PowerEdge R430 Owner's Manual
Dell PowerEdge R430 system overview
23