Using Usb Diskette Or Usb Cd Drives; Hard-Drive Features; Back Panel Features - Dell PowerEdge 1855 Installation And Troubleshooting Manual

Network indicators
USB/video connector

Using USB Diskette or USB CD Drives

Each server module has a USB port on the front of the server module which allows you to connect a custom cable for a diskette drive or USB CD drive. The USB
drives are used to configure the server module.
NOTICE: The system only supports USB 1.1 drives designated by Dell for use with your system. The drive must be horizontal and level to operate
properly.
NOTE: If the drive must be designated as the boot drive, enter the System Setup Program and set the drive as first in the boot sequence (see "Using
the System Setup Program" in the User's Guide). Reset the power on the server module.
Hard-Drive Features
Each server module supports up to two hot-pluggable SCSI hard drives. If only one hard drive is used, a blank must be installed to maintain proper cooling.
See Figure 2-4 and Table 2-3 for information on the hard-drive indicators. Different patterns are displayed as drive events occur in the system.
NOTE: Each server module must have a hard drive or a hard-drive blank installed in each hard-drive bay.
Figure 2-4. Hard-Drive Features and Indicators
Table 2-3. Hard-Drive Status Indicator Patterns
Indicator Activity Indicator
Off None
Activity Green
Status Amber
Amber, blinking
slowly
Amber, blinking
quickly
Back-Panel Features
Off Indicates that the server module does not have a link to the Ethernet switch or pass-through
module.
Green on Indicates that the server module has a valid link to the network switch module.
Green blinking Indicates network activity between the server module and the network switch module.
NOTE:
None Use the custom cable to connect external USB devices and video to the server module.
Indicator Code
Power is off to the server module. Both the activity and status indicators are off.
Shows drive activity.
The rebuild of the drive has stopped or the drive has an error. See
System."
Rebuilding of the drive is proceeding.
Drive is being identified.
External network activity is not reported by this indicator.
"Troubleshooting Hard Drives" in "Troubleshooting Your