Dell E28S Series Owner's Manual page 187

After you finish
1. Install the Trusted Platform Module (TPM). See the Installing the Trusted Platform Module
2. Replace the following:
3. Reconnect all cables to the system board.
4. Follow the procedure listed in the After working inside your system section.
5. Import your new or existing iDRAC Enterprise license. For more information, see the Integrated
6. Ensure that you:
Restoring the Service Tag by using the Easy Restore feature
The Easy Restore feature enables you to restore your system's Service Tag, license, UEFI
configuration, and the system configuration data after replacing the system board. All data is
automatically backed up in a backup flash device. If BIOS detects a new system board and the
Service Tag in the backup flash device, BIOS prompts the user to restore the backup information.
Procedure
1. Turn on the system.
2. Perform one of the following steps:
3. Perform one of the following steps:
section.
a. internal dual SD module
b. heat sink/heat sink blank and processor/processor blank
c. expansion card riser
d. expansion cards
e. integrated storage controller card
f. memory modules
g. cooling shroud
Note: Ensure that the cables inside the system are routed through the cable routing latch.
Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.
a. Use the Easy Restore feature to restore the service tag. See
using the Easy Restore feature
b. If the Service Tag is not backed up in the backup flash device, enter the system service tag
manually. See Entering the system Service Tag by using System Setup
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). See
users on page 189 or
If BIOS detects a new system board, and if the Service Tag is present in the backup flash
device, BIOS displays the Service Tag, the status of the license, and the UEFI Diagnostics
version.
After the restore process is complete, BIOS prompts to restore the system configuration
data.
Press Y to restore the system configuration data.
l
Press N to use the default configuration settings.
l
After the restore process is complete, the system restarts.
on page 187.
Initializing the TPM for TXT users
Installing and removing system components
Restoring the Service Tag by
Initializing the TPM for BitLocker
on page 189.
Dell PowerEdge R430 Owner's Manual
on page 188.
187