Positioning - WAGNER Zip 52 Finishing Operating Manual

VERSION 11/2018

6.5.1 POSITIONING

Procedure:
1. Mount the pump on a frame, trolley or wall mount.
2. Connect the suction system and air supply.
3. Connect the material and air supply in accordance
with the superordinate operating manual.
Designation
1 Product outlet
2 Product return valve
3 Fine Flow Controller (Zip 52 - figure above)
Product filter (Zip 52 PF - figure below)
4 Compressed air connection
5 Atomizing air pressure regulator
6 Product pressure regulator (Zip 52 - figure above)
7 Pump pressure regulator
8 Air suction filter
9 Suction hose
10 Product inlet
Product connection:
Connect the suction hose (on the underside) and the lacquer/air double hose to the
corresponding connections.
Notice: Connect the product hose and air hose correctly.
Connect a suitable spray gun to the other end of the double hose.
For pumps installed in areas subject to explosion hazards, all hoses and pipes must be
made of conductive material and must be grounded. All hoses, pipes and components
connected to the supply line must be designed to operate at the pump's maximum
pressure with the pump working at a vigorous rate.
Compressed air connection:
Connect the device's air inlet fittings to the distribution network.
Caution: The connection must be carried out on the device's fitting. Do not replace the
original connection. Use a pipeline with a suitable diameter for the connection. Provide an
external air cut-off valve for the ZIP52 PF Eco-Finishing.
The pressure must not exceed the maximum value indicated on the type plate.
ORDER NUMBER DOC 2332848
× ×
Zip 52 Finishing
B_06944
1
10
9
8
7
6
B_06947
2
1
10
8
4 5
7
B_06048
3
2
4
5
3
9
25