Cleaning The Filter; Suction Tube Filter; Fine Flow Controller (Zip52 Finishing) - WAGNER Zip 52 Finishing Operating Manual

VERSION 11/2018
8.3

CLEANING THE FILTER

This pump has one filter inside the suction tube and another inside the delivery circuit
(ZIP52 Finishing: Fine Flow Controller - ZIP52 PF Eco-Finishing: product filter).
The filters must be cleaned regularly.
Clean the filter every time that the lacquer color is changed.
Before cleaning the filters, close the air cut-off valve and release the pressure
contained inside the pump and the pipes attached to it.

8.3.1 SUCTION TUBE FILTER

To clean the suction tube filter, remove the spring, take out the suction filter and filter disc
and place them in flushing agent. Then, blow them off with compressed air.
B_04059

8.3.2 FINE FLOW CONTROLLER (ZIP52 FINISHING)

To clean the filter of the Fine Flow Controller, unscrew the union nut (1) from the
metal body and lift the filter cup (2). When doing so, pay attention to the PTFE seal
on the edge. Remove the filter (3) from the base (4), pulling it upward, since it has a
very simple clip fixing. Place the filter cartridge in the flushing agent, then brush and
blow it off. Make sure that the inside of the filter is cleaned with flushing agent and is
blown out.
Re-insert the filter by simply pushing it onto the filter seat until the fixing clip audibly
clicks into place. Do not push the filter downwards any further, to avoid damaging
it. Reposition the filter cup making sure that the PTFE seal is in the perfect position.
Then, screw the union nut tight.
8.3.3 FILTER ZIP52 ECO-FINISHING
To clean the filter of the ZIP52 Eco-Finishing device, simply
remove the upper cover (1) from the filter housing (2), by
unscrewing it, then unscrew the filter's lock-ring (3) and remove
the filter element (4).
Remove the internal spring (5) from the filter element.
Place the filter cartridge and the internal spring in the flushing
agent. Then brush them off and blow them out. Make sure that
the inside of the filter is cleaned with flushing agent and is blown
out.
Reassemble in reverse order, taking care not to damage the
plastic seal (6).
ORDER NUMBER DOC 2332848
B_04060
Zip 52 Finishing
1
2
3
4
3
4
6
1
5
B_04053
2
B_04052
37