Assembly And Commissioning; Training Of Assembly/Commissioning Personnel; Storage Conditions; Installation Conditions - WAGNER Zip 52 Finishing Operating Manual

VERSION 11/2018
6

ASSEMBLY AND COMMISSIONING

6.1

TRAINING OF ASSEMBLY/COMMISSIONING PERSONNEL

The assembly and commissioning personnel must have the technical skills to safely
commission the device.
When assembling, commissioning and carrying out all work, read and follow the
operating manuals and safety regulations for the additionally required system
components.
A skilled person must check to ensure that the device is in a reliable state after it is installed
and commissioned.
6.2

STORAGE CONDITIONS

Until the point of assembly, the device must be stored in a dry location, free from vibrations
and with a minimum of dust. The device must be stored in closed rooms.
The air temperature at the storage location must be between -20 °C and 60 °C (-4 °F and
140 °F).
The relative air humidity at the storage location must be between 10 and 95% (without
condensation).
6.3

INSTALLATION CONDITIONS

The air temperature at the installation site must be in a range between 0 °C and 40 °C (32
°F and 132 °F).
The relative air humidity at the installation site must be between 10 and 95% (without
condensation).
6.4

TRANSPORTATION

The pump can be moved on a trolley or manually without lifting equipment e.g., a crane.
6.5

ASSEMBLY AND INSTALLATION

WARNING
Inclined ground!
Risk of accidents if the device rolls away/falls.
Position the trolley with the double diaphragm pump horizontally.
If the floor is inclined, position the feet of the trolley towards the gradient.
Secure the trolley.
National regulations
Ensure that the national explosion prevention rules and regulations are observed
when setting up the device.
ORDER NUMBER DOC 2332848
Zip 52 Finishing
24