Suzuki Samurai 1986 Service Manual page 299

7) Remove output shaft rear bearing and
retainer together by using bearing puller.
After removing bearing, speedometer drive
gear, thrust washer, output low gear and
needle roller bearing can be removed.
Fig. 14-29
8) Remove front drive clutch hub circlip and
pull clutch hub off shaft by using bearing
puller and puller attachment (special tool A).
NOTE:
Use care to prevent damage to needle roller
bearing in output rear shaft when removing
clutch hub.
Fig. 14-30
9) Remove front bearing by using bearing
puller and puller attachment (special tool
A).
NOTE:
Use care to prevent damage to needle roller
bearing in output rear shaft while bearing is
being removed.
0
Fig. 14-31
10) When input shaft is removed or center case
and rear case are separated, input shaft
bearings may come off. In such a case,
bearings can be removed from shaft by using
bearing puller.
Fig. 14-32
0
14-11