Center Case - Suzuki Samurai 1986 Service Manual

Rear Case
1) Install oil seal in rear case and apply grease
to oil seal lip.
Fig. 14-49
2) Install counter shaft thrust washer to rear
case, bringing its face without depressions
against case and fit its bent portion securely
into groove in case.
NOTE:
Apply ample amount of grease to both surfaces
of washer so as to lubricate sliding surfaces and
prevent washer from moving out of place or
slipping off.
Fig. 14-50
Fig. 14-50
14-18

Center Case

1) Install input shaft front bearing circlip and
oil seal in center case.
Snap ring pliers @ : (09900~6108)
Fig. 14-51
2) Install input shaft to center case.
Fig. 14-52 Fig. 14-52
3) After greasing 0 ring on counter shaft,
insert shaft into center case and secure
shaft with lock plate and bolt.
Fig. 14-53
Fig. 14-53