Suzuki Samurai 1986 Service Manual page 363

Installation Instruction
After removing front axle shaft drive flange,
install parts (shown in below figure) in accor-
dance with the following procedure.
Cone washer
Gasket "A"
\
Fig. 17-5-3
1) After aligning " v " mark on the knob of
free wheeling hub cover with "FREE" posi-
tion, separate free wheeling cover ass'y from
body ass'y .
2) To facilitate installation, apply sealing com-
pound 366E (99000-31090) thin.
Fig. 17-5-4
3) Install gasket "A" and free wheeling hub
body ass'y on front wheel hub.
Tightening torque
.
20 - 30
17-28
Cover
Clutch
N.m
kg-m lb-ft
2.0 - 3.0 14.5 - 21.5
Fig. 17-5-5
4) Put bolt @ into front axle shaft and pull out
the shaft and fit snap ring in the groove of
axle shaft.
Remove bolt @ from axle shaft.
Fig. 17-5-6
5) Install cover ass'y to body ass'y so that
follower stopper nail is fitted into groove of
body ass'y.
NOTE:
Before installing cover ass'y, make sure of
following points.
l " V
Clutch is lifted to the cover side, if not
l
(shown in below figure) it may cause malfunc-
tion.
Gasket is set justly.
l
Fig. 17-5-7
3 . B o l t (a)
, Cover