Lug And Hole; Valve Adjusting Screw And Lock Nut; Timing Marks - Suzuki Samurai 1986 Service Manual

4) Install timing belt tensioner plate to tensio-
ner.
Insert lug of tensioner plate into hole of
tensioner.
4
Fig. 3-645 Lug and hole
5) Install timing belt tensioner, tensioner plate
and spring.
Do not tighten tensioner bolt and stud with
wrench yet.
Hand tighten only at this time.
Be sure that plate movement in arrow
direction as shown in Fig. 3-6-46 causes the
same directional movement of tensioner.
If no associated movement between plate
and tensioner occurs, remove tensioner and
plate again and reinsert plate lug into tensio-
ner hole.
Fig. 3-646 Tensioner installation
1. Tensioner plate
2. Tensioner
3.
L u g
4.
H o l e
Tensioner
1. bolt
2. Tensioner stud
3. Tensioner plate
4. Tensioner
5. Spring
6. Spring damper
6) Before installing timing belt to camshaft
pulley and crankshaft timing belt pulley,
loosen all valve adjusting screws of intake
and exhaust rocker arms fully, or check to
ensure they are loose.
This is to permit free rotation of camshaft
for the following reason; when installing
timing belt to both pulleys, belt should be
correctly tensed by tensioner spring force.
If camshaft does not rotate freely, belt will
not be correctly tensed by tensioner.
Fig. 3-6-47 Valve adjusting screw and lock nut
7) After loosening all valve adjusting screws all
the way, turn camshaft pulley clockwise and
align timing mark on camshaft pulley with
Fig. 3-6-48.
Fig. 3-648 Timing marks
2 . L o c k n u t
1. Camshaft timing pulley
2. Timing mark
3.
"V" mark
4. Belt inside cover
3-49