Brake Pipes And Hoses - Suzuki Samurai 1986 Service Manual

19-7. BRAKE PIPES AND HOSES

INSTALLATION
REMOVAL AND
1) Take out fluid with a cyringe or such.
2) Clean dirt and foreign material from both
hose end or pipe end fittings. Remove brake
hose or pipe.
3)
Reverse removal procedure for brake hose
or pipe installation. When installing hose,
make sure that it has no twists or kinks.
Inspect to see that hose doesn't make contact
with any part of suspension. Check in extreme
right and extreme left turn conditions. If
hose makes .any contact, remove and correct.
Fill and maintain brake fluid level in reser-
voir. Bleed brake system.
CAUTION:
Refer to Fig. 19-38 when connecting
brake flexible hose to brake caliper and
tighten to specified torque.
Be sure to install brake pipe in proper
position referring to Fig. 19-7-2 and
clamp it securely and correctly.
Tightening torque
NOTE:
Be sure to install brake flexible hose E-ring
into hose groove.
Fig. 19-7-1
Upon completion of installation, check each
joint for fluid leakage with brake pedal
depressed.
I
E-ring
19-39