Debugging Ethernet Packet - H3C S9500 Series Command Manual

Command Manual – Ethernet Interface
H3C S9500 Series Routing Switches
The broadcast suppression setting you configured will overwrite the previous
broadcast suppression setting, if any.
With multicast suppression enabled, broadcast suppression is enabled
automatically. However, with broadcast suppression enabled, multicast
suppression can not be enabled.
You cannot enable broadcast suppression and multicast suppression on a board
at the same time. If you have enabled broadcast suppression on some ports of a
board, you cannot enable multicast suppression on the other ports, and vice
versa.
Examples
# Set the broadcast threshold to 20 for Ethernet 1/1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1/1
[Sysname-Ethernet1/1/1] broadcast-suppression 20
# Set the broadcast threshold to 20 for all the interfaces in port group 1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group manual group1] group-member ethernet 2/1/1
[Sysname-port-group manual group1] group-member ethernet 2/1/2
[Sysname-port-group manual group1] broadcast-suppression 20

1.1.2 debugging ethernet packet

Syntax
debugging ethernet packet [ interface interface-type interface-number ]
undo debugging ethernet packet
View
User view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies an interface by its type and
number.
Description
Use the debugging ethernet packet command to enable Ethernet packet debugging
for a specified interface or globally if no interface is specified.
Chapter 1 Ethernet Interface Configuration Commands
1-2