Speed - H3C S9500 Series Command Manual

Command Manual – Ethernet Interface
H3C S9500 Series Routing Switches
By default, the source MAC address for an interface is that of the corresponding VLAN
interface.
Note:
Currently, this command is not supported by the following boards: LSB1GV48DA,
LSB1GV48DB, LSB2GV48DA, LSB1GP48DB, LSB1XP4B, LSB1XP4CA, and
LSB1XP4DB.
Examples
# Set the least octet of the source MAC address to 0x12 for interface Ethernet 3/1/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 3/1/1
[Sysname-Ethernet3/1/1] source-mac-tail 12
# Remove the source MAC address setting for the interface Ethernet 3/1/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 3/1/1
[Sysname-Ethernet3/1/1] undo source-mac-tail

1.1.30 speed

Syntax
speed { 10 | 100 | 1000 | auto }
undo speed
View
Ethernet interface view
Default Level
2: System level
Parameters
10: Specifies the interface rate as 10 Mbps.
100: Specifies the interface rate as 100 Mbps.
1000: Specifies the interface rate as 1,000 Mbps.
auto: Specifies the interface rate is determined through auto-negotiation.
Chapter 1 Ethernet Interface Configuration Commands
1-36