Link-Delay - H3C S9500 Series Command Manual

Command Manual – Ethernet Interface
H3C S9500 Series Routing Switches
Note:
The jumboframe-value argument is in the range 1,552 to 10,236 for the boards
LSB1XP4B, LSB1XP4CA, LSB1XP4DB, LSB1GV48DA, LSB2GV48DA, and
LSB1GV48DB.
By default, the boards LSB1VPNB0, LSB1NAMB0 and LSB1NATB0 allow jumbo
frames with their size being 8,192 bytes. If you execute the jumboframe enable
command for a board of this type, an error occurs.
For FE interfaces, the maximum size of allowed jumbo frames is 1552 bytes.
Examples
# Allow Ethernet frames smaller than 9022 bytes to pass through all the Ethernet
interfaces on the board in slot 4.
<Sysname> system-view
[Sysname] jumboframe enable 9022 slot 4

1.1.21 link-delay

Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default Level
2: System level
Parameters
delay-time: Up/Down suppression time for the physical connection of an Ethernet
interface, in the range 0 to 10 (in seconds).
Description
Use the link-delay command to set the suppression time of physical-link-state
changes on an Ethernet Interface.
Use the undo link-delay command to restore the default.
By default, the suppression time of physical-link-state changes on an Ethernet Interface
is 1 second.
Chapter 1 Ethernet Interface Configuration Commands
1-28