Port-Mode; Reset Counters Interface - H3C S9500 Series Command Manual

Command Manual – Ethernet Interface
H3C S9500 Series Routing Switches
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1]

1.1.26 port-mode

Syntax
port-mode { lan | wan }
undo port-mode
View
Ten-GigabitEthernet interface view
Default Level
2: System level
Parameters
lan: Specifies LAN mode.
wan: Specifies WAN mode.
Description
Use the port-mode command to configure a 10GE interface to operate in LAN or WAN
mode.
Use the undo port-mode command to restore the default.
By default, a 10GE interface operates in LAN mode.
Note:
WAN mode is not supported on LSB1XP4CA, LSB1XK1DB, and LSB1XP4B boards.
Examples
Configure the Ten-GigabitEthernet 1/1/1 to operate in WAN mode.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/1
[Sysname-Ten-GigabitEthernet1/1/1] port-mode wan

1.1.27 reset counters interface

Syntax
reset counters interface [ interface-type [ interface-number ] ]
Chapter 1 Ethernet Interface Configuration Commands
1-33