Command Manual – Ethernet Interface
H3C S9500 Series Routing Switches
Examples
# Enable internal loopback testing on Ethernet 1/1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1/1
[Sysname-Ethernet1/1/1] loopback internal
1.1.23 mdi
Syntax
mdi { across | auto | normal }
undo mdi
View
Ethernet interface view
Default Level
2: System level
Parameters
across: Specifies the MDI mode as across.
auto: Specifies the MDI mode as auto.
normal: Specifies the MDI mode as normal.
Description
Use the mdi command to configure the MDI mode of an Ethernet interface.
Use the undo mdi command to restore the default.
By default, the MDI mode of an Ethernet interface is auto. That is, an Ethernet interface
decides the role of the pins (to send packets or receive packets) through auto
negotiation.
Examples
# Configure the MDI mode of interface Ethernet1/1/1 as across.
<Sysname> system-view
[Sysname] interface ethernet 1/1/1
[Sysname-Ethernet1/1/1] mdi across
1.1.24 multicast-suppression
Syntax
multicast-suppression { ratio | pps max-pps }
Chapter 1 Ethernet Interface Configuration Commands
1-30