Product Overview; Controls - Toro GrandStand TURBO FORCE 74513 Operator's Manual

Product Overview

1. Anti-scalp roller (60-inch
decks only)
2. Front caster wheel
3. Side-discharge chute
4. Engine

5. Controls

6. Control levers
Figure 3
7. Hydraulic tank
8. Fuel tank
9. Platform (down position)
10. Fuel-shutoff valve
11. Battery
12. Mower deck
Controls
Become familiar with all the controls before you start
the engine and operate the machine
Control Panel
g031496
1. Fuel cap
2. Malfunction-indicator light
(MIL)
3. Parking-brake lever
4. Hydraulic-tank cap
5. Hour meter
6. Key switch
7. Throttle control
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) is illuminated
4).
The MIL is the red light located in the console panel.
When the MIL illuminates, make initial troubleshooting
checks.
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
9
(Figure 4).
Figure 4
8. Height-of-cut lever
9. Height-of-cut pin
10. Platform latch
11. Right motion-control lever
12. Power-takeoff switch
(PTO)
13. Left motion-control lever
g031505
(Figure