Replacing The Transmission Belt - Toro GrandStand TURBO FORCE 74513 Operator's Manual

Replacing the Transmission
Belt
Service Interval: Every 1,000 hours—Replace the
transmission belt.
1. Remove the fuel tank; refer to
Fuel Tank (page
2. Remove the hydraulic-reservoir cap.
3. Locate the drain plugs in the bottom of the
transmission and place a drain pan under the
plug (Figure 66).
Figure 65
Removing the
35).
1. Drain plug
4. Allow the hydraulic fluid to drain from the
machine.
5. Remove the lower hydraulic hose
g031344
1. Lower hydraulic hose
2. Transmission belt
6. Remove the tension spring
CAUTION
The spring is under tension when
installed and can cause personal injury.
Wear safety glasses and be careful when
removing the spring.
7. Remove the deck belt from the clutch and clutch
stop (Figure
8. Install the new belt.
9. Install the tension spring and lower hydraulic
hose.
10. Install the drain plugs and torque to 22 to 27
N∙m (16 to 20 ft-lb).
11. Add hydraulic fluid to the fill level.
12. Install the hydraulic-reservoir cap.
44
Figure 66
(Figure
Figure 67
3. Tension spring
(Figure
67).
g032680
67).
g031345
67).