Servicing The Engine Oil - Toro GrandStand TURBO FORCE 74513 Operator's Manual

Inspecting the Filters
1. Inspect the safety filter. If it is dirty, replace both
the safety and primary filters.
Important:
Do not attempt to clean the
safety filter. If the safety filter is dirty, then
the primary filter is damaged.
2. Inspect the primary filter for damage by looking
into the filter while shining a bright light on the
outside of the filter. If the primary filter is dirty,
bent, or damaged, replace it.
Note:
Holes in the filter appear as bright spots.
Do not clean the primary filter.
Installing the Filters
Important:
To prevent engine damage, always
operate the engine with both air filters and the
cover installed.
1. If you are installing new filters, check each filter
for shipping damage.
Note:
Do not use a damaged filter.
2. If you are replacing the inner filter, carefully slide
it into the filter body
3. Carefully slide the primary filter over the safety
filter (Figure 37).
Note:
Ensure that the primary filter is fully
seated by pushing on the outer rim while
installing it.
Important:
Do not press on the soft, inside
area of the filter.
4. Install the air-cleaner cover and secure the
latches (Figure 37).
(Figure 37).

Servicing the Engine Oil

Engine-Oil Specifications
Oil Type: Detergent oil (API service SJ or higher)
Oil Capacity: 1.65 L (56 fl oz) with the filter; 1.50 L
(51 fl oz) without the filter
Viscosity: See the table below.
Note:
Use a synthetic oil with 5W-20 or 5W-30 rating,
up to 4°C (40°F).
Note:
Synthetic oils provide better starting when the
temperature is below -23°C (-10°F).
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep your hands, feet, face, clothing and
other body parts away the muffler and other
hot surfaces.
Important:
Do not overfill the crankcase with oil
because damage to the engine may result. Do not
run engine with oil below the low mark because
the engine may be damaged.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check the engine-oil level as shown in
39).
30
Figure 38
g012991
(Figure