Servicing The Fuses; Drive System Maintenance; Adjusting The Tracking - Toro GrandStand TURBO FORCE 74513 Operator's Manual

Servicing the Fuses

The electrical system is protected by fuses and
requires no maintenance. If a fuse blows, check the
component or circuit for a malfunction or short.
1. Release the cushion from the rear of the
machine.
2. Pull out the fuse to remove or replace it
52).
3. Install the cushion to the rear of the machine.
Note:
Ensure that the correct-size fuse is
installed Figure 52.
Figure 52
1. Ignition fuse—15 A
2. Accessory-port fuse—15
A
(Figure
g031517
3. Power takeoff (PTO)
fuse—10 A
4. Infocenter fuse—7.5 A
Drive System
Maintenance

Adjusting the Tracking

If you push both motion-control levers forward the
same distance and the machine pulls to 1 side, adjust
the tracking as follows.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Release the cushion from the rear of the
machine; refer to
Rear Access (page
Note:
For easier access, you can also remove
the fuel tank; refer to
(page 35).
4. Rotate the left control rod in quarter-turn
increments until the machine tracks straight
(Figure 53).
Note:
If the machine pulls to the right, shorten
the control rod by rotating it to the right. If the
machine pulls to the left, lengthen the rod by
rotating it to the left.
Note:
Adjust only the left control rod to match
the left wheel speed to the right wheel speed.
Do not adjust the right wheel speed, as this
positions the right motion-control lever out of the
center for the control panel neutral-lock slot.
Important:
Do not rotate the control rod too
far, as this may cause the machine to creep
in neutral.
1. Rotate left to lengthen the
rod.
2. Left control rod
5. Check for proper tracking, and adjust the rod
as necessary.
38
Releasing the Cushion for
26).
Removing the Fuel Tank
Figure 53
3. Rotate right to shorten the
rod.
g031531