Controls System Maintenance; Adjusting The Motion-Control Levers - Toro GrandStand TURBO FORCE 74513 Operator's Manual

13. Run the machine for 10 minutes and verify that
the hydraulic fluid is at the correct level.
Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the motion-control levers.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Push the motion-control levers down out of the
N -
EUTRAL LOCK
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure 68).
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
Note:
To adjust the right motion-control lever
horizontally, adjust the cam.
5. Release the cushion from the rear of the
machine.
6. Loosen the nut holding the cam
45
position (Figure 68).
Figure 68
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure
g009436
69).