Pre-Maintenance Procedures; Releasing The Cushion For Rear Access - Toro GrandStand TURBO FORCE 74513 Operator's Manual

Maintenance Service
Interval
Every 300 hours
Every 500 hours
Every 600 hours
Every 800 hours
Every 1,000 hours
Before storage
Yearly
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the spark-plug wires from the spark plugs
before you do any maintenance. Set the wires aside so that they do not accidentally contact
the spark plugs.
Pre-Maintenance
Procedures
Releasing the Cushion for
Rear Access
You can release the cushion for rear access to the
machine for maintenance or adjustment.
1. Lower the platform.
2. Loosen the twist knobs on each side of the
machine (Figure
Maintenance Procedure
• Replace the primary air filter (more often in dirty or dusty conditions).
• Check the inner air filter (more often in dirty or dusty conditions).
• Adjust the caster-pivot bearing.
• Check the hydraulic-fluid level.
• Change the hydraulic filters and hydraulic fluid.
• Replace the inner air filter (more often in dirty or dusty conditions).
• Replace the fuel filter.
• Replace the transmission belt.
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
• Grease the torsion idler.
• Grease the front caster pivots (more often in dirty or dusty conditions).
• Grease the caster-wheel hubs.
• Grease the motion controls.
• Apply anti-seize compound to the cushion knobs.
32).
1. Twist knob
3. Remove the cushion and lower it to the platform.
4. Perform any maintenance or adjustment on the
machine.
5. Raise the cushion, and slide it onto the pins on
both sides of the machine.
6. Tighten the twist knobs.
26
Figure 32
2. Cushion
g032556