Procedure H. Attaching K1 Or K1-Sb Under K2-Bump - L-Acoustics WST K2 Rigging Manual

K2 WST enclosure
®
RIGGING MANUAL
VERSION 1.0
PROCEDURE H. Attaching K1 or K1-SB under K2-BUMP
1. Slide out K1-SB front rigging arm and pin it at 0° on both sides.
2. Attach the K2-BUMP to the K1 elements block.
Remove the K2-BUMP rear and front pins on both sides.
Lower the K2-BUMP so it rest on the topmost enclosure. Rotate the rear rigging arm and pin it on the frame.
Pin the front rigging arm on the frame.
w w w . l - a c o u s t i c s . c o m 3 6 / 52
K2_RM_EN_1.0