Scanning Channels; Switching Scanning On Or Off - Codan NGT AR Getting Started Manual

Scanning channels

Switching scanning on or off

NGT Transceiver Getting Started Guide
Before you can switch scanning on, you need to allocate some
channels to be scanned. If Quick Start is available, you can
create a scan list from channels programmed into the
transceiver (see page 65, Using Quick
not available, your system administrator must allocate some
channels to a network, then enable scanning of this network.
To switch scanning on or off:
1
Press SCAN.
Scanning is toggled on or off.
NOTE
When scanning is switched on, mute is also switched on.
If you press PTT while the transceiver is scanning, the scan is
paused.
SCAN is also used to end a call then
resume scanning.
Getting started
Start). If this feature is
17