Codan NGT AR Getting Started Manual page 25

Call type
Selective
Send Position
If this prompt is
displayed...
Select network
My address?
Select chan/mode
NGT Transceiver Getting Started Guide
Icon Used for...
Sending a selective call to a remote transceiver.
Sending your GPS position to a remote
transceiver. A GPS receiver must be connected
to and enabled in your transceiver, or a GPS
position must be entered in the My GPS entry
in the Address List.
1
If you are prompted for details about the call, use the
information in the following table to enter them, then
press CALL.
Do this...
• select the network in which you want to make the call
• select or enter the self address from which you want to send
the call
In an ALE/CALM network:
• select <auto> if you want the transceiver to select the best
channel/mode for the call, starting with the channel on
which the most recent successful link was established, or
• select the channel/mode you want to use to make the call
In a Codan Selcall network:
• select the channel/mode you want to use to make the call
and check that it is clear of voice and data traffic
NOTE
To abort the call before a connection to the
other station is made, press PTT.
Getting started
15