Scanning Channels - Codan 2110 Getting Started Manual

Scanning channels

Switching scanning on or off
Pausing scanning
2110 SSB Transceiver Getting Started Guide
Before you can switch scanning on, you need to allocate some
channels to be scanned. If you have Quick Start enabled you
can create a scan list from channels programmed into the
transceiver (see page 49, Using Quick
disabled, your system administrator will allocate some
channels to a network, then enable scanning of this network.
To switch scanning on or off:
1
Press SCAN.
Scanning is toggled on or off.
NOTE
When scanning is switched on, mute is also switched on.
You cannot use PTT while the transceiver is scanning.
To pause scanning:
1
Do one of the following:
• to pause scanning on the current channel/mode,
press
• to pause scanning and scroll to another channel/mode,
press or
SCAN is also used to end a call.
If the transceiver was scanning before the
call was sent or received, it resumes
scanning. If the transceiver was not
scanning before the call, press SCAN to
switch scanning on.
Getting started
Start). If this feature is
41