Appendix B Using Quick Start
Opening and closing Quick Start
NGT Transceiver Getting Started Guide
Quick Start provides simple methods to configure your
transceiver to a basic operating state.
Quick Start is available if your transceiver has not been
programmed with a profile, or contains only one station self
address and network names from this default list:
•
*Voice
•
*Selcall
•
*CALM
•
!Default
When you hold
Start entries, for example, Add/Edit channel,
Set scan list etc. If these entries are not
displayed, then Quick Start is not available to
you.
In countries that do not permit programming of
NOTE
transmit frequencies using the handset, you are
not able to add channels using Quick Start; this
is achieved using NSP.
For detailed information on programming your
transceiver without Quick Start see the
reference material on the enclosed CD.
To open Quick Start:
1
Hold
.
To close Quick Start:
1
Press or hold
, you should see the Quick
.
65
Need help?
Do you have a question about the NGT AR and is the answer not in the manual?