Table of Contents
Advertisement
Enter Setup
Smart Stand Mode
After this feature is turned on, the scanner will switch from its current scan mode to the Sense mode when it is inserted in
the stand, and it will operate in its previous scan mode when it is removed from the stand.
Off
Bad Read Message
You may scan the appropriate barcode below to select whether or not to send a bad read message (user-programmable)
when a good read does not occur before trigger release, or the decode session timeout expires.
** Bad Read Message OFF
Set Bad Read Message
A bad read message can contain up to 7 characters (HEX values from 0x00 to 0xFF). To set a bad read message, scan the
Set Bad Read Message barcode, the numeric barcodes representing the hexadecimal values of desired character(s) and
the Save barcode. The default setting is "NG".
** Exit Setup
** On
Bad Read Message ON
30
- Quick Links:
- Barcode Programming
Hide quick links:
Advertisement
Table of Contents
