Keyboard; Keyboard Beep; Keyboard Lock; Keyboard Emulation - Applied Precision RS 2130 User Manual

Reference Standard RS 2x30, RS 1x30
User's Guide

5.3 Keyboard

Keyboard functions and parameters can be controlled remotely.

5.3.1 Keyboard Beep

Beep after every press of any key of keyboard can be controlled by menu item
System / Keyboard / Beep or by remote interface commands:
SYSTem:KEYBoard:BEEP?
Request for state of keyboard beep function. Answer is: 0 (disabled) or 1 (enabled).
SYSTem:KEYBoard:BEEP {<state>}
Setting of keyboard beep function. Parameter is: 0 (disabled) or 1 (enabled).

5.3.2 Keyboard Lock

Keyboard Lock function can be used for locking keyboard of device. Keyboard can be configured to
automatically lock after switch on of device. Keyboard can be locked without using password manually
by menu item or by command. Locked keyboard can be unlocked by remote command (no password
is needed) or by keyboard when password followed by key OK is typed. Special password used only
for unlocking keyboard can be defined in menu.
For unlocking keyboard can be used also calibration password (needed for entering calibration
submenu). Function is controlled by submenu System / Keyboard or by remote interface commands:
SYSTem:KEYBoard:LOCK?
Request for state of Keyboard Lock. Answer is: 0 (not locked) or 1(locked).
SYSTem:KEYBoard:LOCK
Keyboard locking.
SYSTem:KEYBoard:UNLock
Keyboard unlocking.
SYSTem:KEYBoard:LCKatswitchon?
Request for setting of AutoLockAtSwitchOn parameter. Answer is: 0 (OFF) or 1 (ON).
SYSTem:KEYBoard:LCKatswitchon {<state>}
Setting of AutoLockAtSwitchOn parameter. If this parameter is ON then device starts operate after
switch on with locked keyboard. Parameter <state> is 0 (OFF) or 1 (ON).

5.3.3 Keyboard Emulation

Emulation of press of any key can be done by remote interface command:
SYSTem:KEYBoard {<code = 0-255>}
Send of key code to device. Device will "press corresponding key".
www.appliedp.com
22 RS-UG91-EN