Menu Control Keys; Parameter Value Editing Keys; Functional Key And Keys Combinations - Applied Precision RS 2130 User Manual

DOWN
UP
ESC
LEFT and DEL
RIGHT and OK
F1, F2...
By parameter type item selection, editing mode will start and a change of this parameter value can be
performed.
If the parameter value is optional (i.e. ON/OFF, ENABLED/DISABLED...), the options are offered with
the highlighted actual value, UP and DOWN keys can be used for other value selection and approved
using OK key or skip out without accepting change.
If the parameter value is of numeric type, the actual value is offered as start value of the editing mode.
The value is highlight what indicates the possibility of value editing (the first used key is UP, DOWN,
LEFT, RIGHT or BS respectively), delete (the first used key is DEL) or begin overwrite. Key functions
in editing mode are as follows:
•
DOWN
•
UP
•
LEFT
•
RIGHT
•
OK
•
ESC
•
DEL
•
EXP
•
FUNC
•
+/-
•
'.'
•
0,1,2 ... 9

3.1.4 Functional Key and Keys Combinations

Functional key is:
"Func" key in bottom line of front panel (in newer devices with 29 keys membrane keypad)
-
or
- red SHIFT key in bottom line of front panel (in older devices with 33 keys panel keypad)
Functional key can be used in key combinations.
In some key combinations as functional key works also key +/-.
www.appliedp.com

3.1.2 Menu Control Keys

- pointer shift of the actual highlight item down, if the pointer is set at the last item,
it will move to the first one,
- pointer shift of the actual highlight item up, if the pointer is set at the first item, it
will move to the last one,
-skip from the menu mode to the basic device state without considering the actual
menu level,
-shift in a cascade menu structure one level up, in direction to the main menu; if
the main menu was the actual level than the skip out and return to the basic
device state will happen,
- actual (highlight) item selection
-item selection with used attached soft key

3.1.3 Parameter Value Editing Keys

skip to the text end,
skip to the text beginning,
pointer shift one character left,
pointer shift one character right,
new value acknowledgement and editing mode termination,
editing mode termination without changes acceptation,
delete the character before the pointer and move to left by one char position
entry of the exponent character
no special meaning so far (for new FW versions)
entry of '-' character or overwrite of the character '-' by '+' character
entry of '.' character
entry of the given number
Reference Standard RS 2x30, RS 1x30
RS-UG91-EN
User's Guide
11