Quantities Menu; Harmonic Graph Menu; Contrast Menu; Control Port Initialization Menu - Applied Precision RS 2130 User Manual

This menu contains list of quantities which device measures or calculates from the measured quantities.
Displaying of selected quantities may be switched-on (ON) or switched-off (OFF). Up to seven
quantities can be displayed simultaneously. In case that only one quantity is chosen, the Large font
parameter, which determines if measured quantities are displayed in capitals or small fonts, is applied.
Harm. graph
Background
Max. freq.
Increase (+)
Decrease (-)
Store
Signal OUTx
www.appliedp.com

3.2.25 Quantities Menu

3.2.26 Harmonic Graph Menu

- parameter enabling (ENABLED) or banning (DISABLED) harmonic items of
measured signals graph displaying, if the FFT module of signal analysis is
present,
- parameter switching-on (ON) or switching-off (OFF) displaying of the noise
background in the graph of harmonic items of measured signals,
- parameter setting the maximal frequency displayed in the graph of harmonic
items of measured signals

3.2.27 Contrast Menu

- display contrast increase
- display contrast decrease
- display contrast value storage into the device memory

3.2.28 Control Port Initialization Menu

- parameter setting the initialization value (set after the device switch on) on the
appropriate bite of the user control port (value LOW corresponds to the logical 0,
and value HIGH to logical 1, respectively)
Reference Standard RS 2x30, RS 1x30
RS-UG91-EN
User's Guide
19