Effects; Static Mode - ProLights ECLIPSEPARFC User Manual

16

EFFECTS

The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the MENU button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Effects icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to select the mode of operation: Effects 1, Effects 2, Effects 3
• Press the ENTER button to confirm your choice.
• Press the MENU button repeatedly to exit the menu and save changes.
The unit will go into automatic mode by executing the program automatically.

STATIC MODE

This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until the display shows Static, then press the button ENTER.
• Select Fixed Color through the buttons UP/DOWN, then press the button ENTER.
• Set the colors R, G, B, W, RG, RB, RW, GB, GW, BW RGB, RGW, RBW, GBW, RGBW, through the buttons UP/DOWN,
then press the button ENTER.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
NOTE: If the projector is in Blackout mode before synchronizing with the DMX signal, and if the DMX signal
is lost, the projector will remain on according to the last received DMX value.
If the projector was in STATIC or AUTO mode before synchronizing with the DMX signal, if the DMX signal
is lost, the projector will return to the previously set STATIC or AUTO.
ECLIPSEPARFC