Advanced; Information; Master / Slave; Effects Mode - ProLights ECLJZIPLZ1530 User Manual

3.9 ADVANCED

You can change the parameters for the device by following these steps:
• Press on MODE to enter the menu mode.
• Press on UP/DOWN to select Advanced. Press the button ENTER to confirm.
• Press on UP/DOWN to select the desired option and press on ENTER to confirm:
- Dimmer Mode - Adjusting the dimmer. Enter in Dimmer Mode to select specific dimming curve.
Particularly when set:
• Off: The increase in light intensity is linear.
• Dimmer 1: dimmer curve with low fade.
• Dimmer 2: dimmer curve with medium fade.
• Dimmer 3: dimmer curve with high fade.
- LED Frequency - To adjust the frequency of the LEDs. Select the frequency 600 Hz - 25 KHz using the UP/
DOWN and press on ENTER to confirm the selection.
- Fan Mode - Fan speed. Select the desired fan speed Auto, On, Silent, through UP/ DOWN.
- Factory Reload - To reset the unit. Select Yes or No and select ENTER to confirm.
• Press repeatedly on MODE to return the menu mode.

3.10 INFORMATION

To view all the information on the device, proceed as follows:
• Press on MODE to access the main menu. Press on UP/DOWN to select Information, then press on ENTER
to access the next menu.
• Press on UP/DOWN to scroll through the menu, then select one of the following information and press
on ENTER to display it.- Fixture Time - Through the Fixture Time function, the operating time of the
projector can be shown on the display.
- Fixture Time - To view the operating time of the projector.
- Software Version - To view the firmware version will show on the display.
- UID - To view the identification ID for the RDM control.
• Press repeatedly on MODE to return the menu mode.
3.11 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Press on MODE button so many times until the display shows Stand Alone, then press on ENTER.
• Select Master/Slave, then press ENTER.
• Using UP/DOWN, select the desired mode and then press ENTER.
• Press on MODE to go back or to meet the waiting time to exit the setup menu
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 15).
• Set the slaves to the same DMX modes.
NOTE: the unit, set in Static or Effect mode, always appears to be Master.

3.12 EFFECTS MODE

This fixture has a built-in automatic program. To access this, please see the below instructions:
• To enter the Effects mode, press MODE to access the menu, using UP/DOWN select Stand Alone, then
press ENTER to confirm.
• Use UP/DOWN to select the desired program Effect 1, Effect 2, Effect 3, Effect 4, then press ENTER to confirm.
• Set the value (1 - 100), through UP/DOWN, then press ENTER to confirm.
ECLJZIP
11