Post-Installation Check; Hardware And Software Settings - Endress+Hauser Proline Prosonic Flow 91W Brief Operating Instructions

Proline Prosonic Flow 91W
Fig. 21: Connecting the connecting cable
the connecting cables ä 23.
This completes the mounting process. The sensors can now be connected to the transmitter via
2.8

Post-installation check

• Are cables or the device damaged (visual inspection)?
temperature and pressure, ambient temperature, minimum fluid conductivity, 
• Does the device correspond to specifications at the measuring point, including process
measuring range, etc.?
• Are the measuring point number and labeling correct (visual inspection)?
• Have the inlet and outlet runs been observed?
• Is the measuring device protected against moisture and direct sunlight?
3

Hardware and software settings

Diverse hardware and software settings are possible or necessary (e.g. device address
configuration) for measuring devices with PROFIBUS DP or FOUNDATION Fieldbus type of
communication. For a description of the possible settings and the exact procedure that applies
for the different types of communication, see the associated Operating Instructions on the CD.
Endress+Hauser
Hardware and software settings
A0011376
21