Sony PCS-G70 Operating Instructions Manual page 54

For details on the standby mode, see
"Standby Mode Function" on page 29.
Last Number Registration
Allows you to select whether to register the
remote party in the Phone Book after the
conference is finished.
On: If the remote party is not registered in
the Phone Book, the "Register this
participant in the list?" message appears
on the monitor screen when conference
finishes. When you select "OK", the List
Edit menu opens.
Off: The message above does not appear and
remote party registration does not take
place.
Control by Far End
When "Far End Camera Control" is set to
"On" in the Communication Setup menu,
you can temporarily reject the camera
control command transmitted by the remote
party.
On: Accepts the camera control command.
Off: Rejects the camera control command.
Device Setup Page 2/2
General
Device Setup
Page: 2/2
Language
IR Repeater Mode
T.120 PC Address
Language
Allows you to select the menu and display
language used by the system. You can select
from the following languages: English,
French, German, Japanese, Spanish, Italian,
Simplified Chinese, and Portuguese.
IR Repeater Mode
Allows you to select the Remote Controller
mode of the IR repeater. You should
normally select "MODE 1".
54
Registering Local Information
English
MODE1
. . .
Save Cancel
MODE 1: Select when using mode 1. This
setting does not usually need to be
changed.
MODE 2: Select when using mode 2. Select
this mode when the system does not
operate properly under "MODE 1".
MODE 3: Select when using mode 3.
MODE 4: Select when using mode 4.
T.120 PC Address
When conducting a data conference based
on the T.120 standard using NetMeeting,
enter the IP address of the computer. (Used
for ISDN connections.)
For details on data conferences based on the
T.120 standard, see "Conducting a Data
Conference Using NetMeeting – T.120 Data
Conference" on page 138.
Menu Screens Page 1/3
General
Menu Screens
Page: 1/3
Time Display
Display Terminal Name
Character Input Help
Time Display
Allows you to select whether you display the
elapsed time on the monitor screen during a
conference.
On: Displays the elapsed time.
Off: Does not display the elapsed time.
Note
During communication, some items that
cannot be modified are also displayed.
Display Terminal Name
Allows you to select whether to display the
connected terminal names on the monitor
screen at the time of disconnection.
Off: Not to display the terminal names.
Show temporarily: Display the terminal
names for a brief moment.
Always show: Display the terminal names.
On
Off
On
Save Cancel