Sony PCS-G70 Operating Instructions Manual page 79

5
Press the V, v, B or b button to select "Dial", and then press the PUSH
ENTER button of the Remote Commander. Or press the CONNECT/
DISCONNECT (
The system begins dialing the IP address ISDN telephone number entered in
step 4. "Dialing" appears on the monitor screen, and the ON LINE indicator
(blue) on the Communication Terminal blinks.
When the system connects to the remote system, the message "Meeting starts!"
appears on the screen, and the ON LINE indicator stops blinking and lights in
blue.
Note
When "More Options Enable" in the Dial Setup menu is set to "On", a dialog box
appears after step 5.
More Options Enable: The Detail Dial menu is displayed.
Dial: Call the remote party.
Cancel: Cancel a call.
For details about the Detail Dial menu, See "To call a remote party not
registered in the Phone Book" on this page.
6
Press the V, v, B or b button to select "Dial", and then press the PUSH
ENTER button of the Remote Commander.
To call a remote party not registered in the Phone Book
1
Use the V, v, B or b button on the Remote Commander to select "Detail
Dial", then press the PUSH ENTER button, or press the CONNECT/
DISCONNECT (
The Detail
IP
Note
Pressing the number buttons on the Remote Commander opens the
menu, allowing direct entry of the IP address or the ISDN telephone number with
the number buttons.
2
Use the V, v, B or b button to select "Line I/F", then press the PUSH
ENTER button. The submenu appears. Press the V or v button to select the
line type to be used to connect to the remote party, then press the PUSH
ENTER button.
/ ) button on the Remote Commander.
/ ) button on the Remote Commander.
Dial menu appears on the screen.
Detail Dial
Line I/F
IP
LAN Bandwidth
1024 Kbps
Dial Save Cancel
Starting a Conference by Calling a Remote Party
Detail
Dial
79