Seagull Models GIANT SCALE P-47 RAZORBACK 50-61cc/EP ARF Assembly Manual page 31

22.
Epoxy.
Use medium CA to glue the pushrod
standof to the inside of the fuselage and
the pushrod tube.
23.
Reinstall the servo horn by sliding the
connector over the pushrod wire. Center
the throttle stick and trim and install the
servo horn perpendicular to the servo
center line.
24.
Move the throttle stick to the closed posi-
tion and move the carburetor to closed.
Use a 2.5mm hex wrench to tighten the
screw that secures the throttle pushrod
wire. Make sure to use threadlock on the
screw so it does not vibrate loose.
COWLING
Please see below pictures.
1.
2.
3.
31