Figure 76. Rgh Wall Mounting Bracket - AT&T System 85 Installation And Test

L BRACKET
HINGE
SWINGAWAY
BRACKET
WING
NUTS
RETAINER
BRACKET
• Figure 76. RGH Wall Mounting Bracket
1. Mount a plywood backboard to the wall. The bottom of the RGH should be a least 24
inches from the floor; mount the plywood accordingly. The plywood must be securely
attached to the wall studs, because the weight of the wall mounting bracket and RGH
exceeds 100 labs. The backing should measure at least 28 inches wide by 22 inches high
and be at least 3/4-inch thick.
2. Place two of the 3/4-inch wood screws 25-3/8 inches apart near the top of the plywood
backing.
3. Insert the screws far enough to temporarily hold the wall mounting bracket.
4. Holding the wall mounting bracket with the slotted holes at the top, place the bracket
over the two screws; then tighten.
5. Insert wood screws in remaining seven holes of the wall mounting bracket, and then
tighten.
6. Loosen the wing nut clamps on the retainer bracket. Slide the bracket to the right to
free the the hinged bracket.
7. Swing the hinged bracket away from the wall.
8. Position the Remote Group Housing so the rear of the Remote Group Housing faces the
hinge.
9. Slide the U bracket on the underside of the Remote Group Housing until the rear edge
meets the L bracket.
10. Tighten the screw on the back of the hinged bracket against the base of the Remote
Group Housing.
11. Swing the hinged bracket with the mounted Remote Group Housing closed.
12. Slide the retainer bracket to the left, and tighten the wing nuts to secure the hinged
bracket.
Page 114